Browse over 9,000 car reviews
How to change the oil on a Toyota Corolla?
The process is the same as any other car. Look up what grade of oil your car needs and how much oil capacity it has, all of which is listed in your owner's manual, and purchase a brand new oil filter. Drive the car for approximately 10 minutes to ensure the oil is warm as this makes it easier to drain. Park the car on a level surface, open the bonnet and loosen the oil filler cap so it is just resting on top of the filler tube, then slide a drain tray underneath your engine. There will be a small flap in the undertray to be undone so you can access the 14mm oil drain plug with a ring spanner. Undo the sump plug being careful not to burn yourself as the hot oil rushes out. Let it drain for 10minutes, then do up the sump plug with a new washer and being careful not to over-tighten the plug - do it snug, then turn it another quarter-turn. Slide the drain pan under the oil filter and remove this again being cautious to not splash hot oil on yourself. Before installing the new oil filter check the rubber seal came off with the old filter, then smear a little fresh oil on the new filter's rubber seal before winding it on and doing it up a quarter-turn past snug. Fill the engine with fresh oil as per the owner's manual. Once you have confirmed there is no oil leaking out, start the engine, let it warm up and then check the oil level. If you cannot reach under your car to undo the oil filter or sump drain plug, use the factory jacking points recommended in the owner's manual to lift the car off the ground at the front and rear, lifting the front first, and use four weight-rated chassis stands to support the car at the factory recommended support points.
Comments